Build a Cardboard Gluing Support Bridge

WHAT TO GATHER

Your starting kit.

Clean, dry cardboard with uncrushed edges
A ruler, pencil, and scissors suitable for the board
Paper glue or paper tape as required by the joins
Scrap cardboard and a protective work mat

STEP 01

Measure and prepare

Cut two identical rectangular side supports with broad feet and a flat top edge.

STEP 02

Lay out the construction

Cut a top platform 40 by 180 mm and fold shallow tabs along its short ends.

STEP 03

Join and shape

Glue the tabs to the supports so the platform stands about 40 mm above the table, then dry it upright.

STEP 04

Check the result

Use only lightweight paper pieces; this temporary support is not a shelf or load-bearing stand. Let all adhesive dry before fitting the intended lightweight contents. Place the project on a flat surface and check that its joints sit square. If a slot tears or a wall leans, remake that piece from sound cardboard rather than hiding the weak join with decoration.

STEP 05

Finish and keep

Smooth exposed rough edges with a thin paper covering where needed, without blocking working slots. Keep the project away from water and heat. Recheck the joints after a few uses and replace a worn piece if it bends or loses its shape.

Before you begin.

How wide should I cut the slots?

Measure the cardboard thickness and test a slot on an offcut. The pieces should slide together with light pressure; forcing them can crush the corrugation and weaken the join.

What should I check before beginning?

Use only lightweight paper pieces; this temporary support is not a shelf or load-bearing stand.

Original editorial project guidance. Images are AI-generated concepts, not photographs of tested finished projects. Practice on inexpensive materials and follow tool and material instructions. Sources & approach.

Save to Pinterest ↗

More cardboard projects ↗