Make a Cardboard Embroidery Hoop Spacer

WHAT TO GATHER

Your starting kit.

Clean, dry cardboard with uncrushed edges
A ruler, pencil, and scissors suitable for the board
Paper glue or paper tape as required by the joins
Scrap cardboard and a protective work mat

STEP 01

Measure and prepare

Measure the outside diameters of the empty hoops and draw generously sized circles on a cardboard divider.

STEP 02

Lay out the construction

Cut out the circles, leaving broad bridges of cardboard between them.

STEP 03

Join and shape

Place the divider flat inside a shallow storage box and use the openings to separate empty hoops on the base below.

STEP 04

Check the result

Do not force valuable stitched work into a cardboard aperture; this organizer is for empty hoops. Let all adhesive dry before fitting the intended lightweight contents. Place the project on a flat surface and check that its joints sit square. If a slot tears or a wall leans, remake that piece from sound cardboard rather than hiding the weak join with decoration.

STEP 05

Finish and keep

Smooth exposed rough edges with a thin paper covering where needed, without blocking working slots. Keep the project away from water and heat. Recheck the joints after a few uses and replace a worn piece if it bends or loses its shape.

Before you begin.

How wide should I cut the slots?

Measure the cardboard thickness and test a slot on an offcut. The pieces should slide together with light pressure; forcing them can crush the corrugation and weaken the join.

What should I check before beginning?

Do not force valuable stitched work into a cardboard aperture; this organizer is for empty hoops.

Original editorial project guidance. Images are AI-generated concepts, not photographs of tested finished projects. Practice on inexpensive materials and follow tool and material instructions. Sources & approach.

Save to Pinterest ↗

More cardboard projects ↗